DIY Accuphase E210 Modified Power Amplifier Board
Output Rower: RMS :50-150W 8 ohms
VOLTAGE GAIN: 18 times
Front And Rear Stage Combined Output gain: 100 times
Frequency Response Range: 20HZ -20KHZ (-0.1 DB).
THD+N: 0.005% - 0.008%
SR: 20V/US
Damping Coefficient: 100
Radiator Recommended Size: Mono iIs greater than 200Grams
Supply VoltageRange: DC ±25V ~ DC ±55V recommended voltage DC ± 40V.
Amplifier Wiring Instructions:
Power supply VCC+, GND, VEE- A total of three line power supplies.
Input signal INPUT + - , the input signal has a total of 2 lines.
Output OUT+ Connect the speaker positive, GND to the speaker ground.
PCB size: 82*76MM
PCB mounting hole distance: 74MM left and right holes. Upper and lower hole spacing 69MM
Power tube lateral installation distance: 22MM
Note:
The finished boards are all debugged. It is generally not recommended to adjust the quiescent current again during use.
Package:
1* Power Amplifier Board
